Gps Input Module Alarm Defaults - Symmetricom SSU-2000 Technical Reference

Chapter 6 Alarms and Events
GPS Input Module Alarms and Events
Table 6-12. GPS Input Module Alarm and Event Messages (Continued)
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
132 Disable, GPS Module, COML
133 Restart, in 5 seconds, COML
134 Cannot Enable, GPS
Module, COML
144 Zero Phase, B, COML
193 Priority, 3, COML
194 Prov PQL, 2, COML
195 ElMask, POS 10, COML
197 Satellite Ignore, 3, COML
198 Position, 300 AvgCnt, COML
199 Tracking Mode, On, COML
200 Pos Set by Rec, Information
Locked, COML
201 Engine Set Time, GPS
203 PDOP, 2, COML
224 IoName, Set
251 Err Delay, (0), 10 sec, COML
252 Alm Level, (2), Maj, COML
253 Elevate Time 86400 sec,
COML
254 Setup, Save, COML
Table 6-13. GPS Input Module Alarm Defaults
ID Description
000 Hdw Config
001 Tracking
002 Antna Conntd
003 Antna Shorted
310 SSU-2000 Technical Reference
Corrective Action
The Input module has been disabled.
Module re-boot.
Internal firmware conflict. Restart module; if the problem persists,
call SGS.
User has forced the phase to be cleared.
User has changed the Priority level on the GPS input module to the
level shown.
User has changed the Priority quality level to the level shown.
User has changed the elevation mask on the input module to the
level shown.
User has set the GPS engine to ignore the satellite number
indicated.
The position has been calculated.
User specified GPS positioning mode has been set.
User specified GPS positioning mode has been set to Calc and the
position has been recalculated and locked in.
System time has been set to UTC by the GPS module.
User has changed the PDOP on the GPS input module to the
setting shown.
A user has set the IO Name.
An alarm delay time change.
An alarm level change.
An alarm elevation time change.
User defaults have been set and saved.
Alarm Level
Major
Major
Major
Major
Description/
12713020-003-2 Revision F.01 – January 2007