Table of Contents
Advertisement
Chapter 2 TL1 Reference
TL1 Command and Response Conventions
indicates the end of the message
;
and
<cr>
(LF) codes used as a line terminator and may be used separately or combined
The ASCII cancel code character (hex 18) can be used to cancel a partially sent
command and clear the input buffer.
Input Command Message Conventions
Command messages entered and sent by the user determine the action that the
SSU-2000 will take. Command messages are input messages, and are always
followed by an acknowledgment or output response message.
The format for the input command message is:
cmd:tid:[aid]:ctag[:[gb]:<other>;<cr lf>
where:
(Command) is a descriptive string of letters that represents the input
cmd
command. The command string consists of a standard TL1 command verb,
followed by one or two command modifiers. The modifiers identify the subject of
the command verb and each may be as many as five characters. If two modifiers
are used, they must be separated by dashes:
(Target Identifier) represents the name assigned to the SSU-2000. The
tid
assigned name must be either null or match the name assigned to the SSU-2000.
If the tid is not null, it may must begin with a letter and may contain up to 20
alphanumeric characters. See
Note: The SSU-2000 does not generate a response for entries
without a valid tid.
(Access Identifier) is an optional field that represents the shelf, module, and
aid
port within the SSU-2000 to which the command is addressed or to which the
response applies. The aid must be null (::, indicating ALL or not used), ALL
(indicating all modules and ports related to the command type), or the aid
assigned to an entity in the SSU-2000.
Follow these conventions for entering the aid field:
SxAy-z
or
ALL
where:
26
SSU-2000 Technical Reference
or
indicate the ASCII carriage return (CR) and line feed
<lf>
<cr lf>
Set
verb- mod1- mod2
Name, on page
162.
12713020-003-2 Revision F.01 – January 2007
.
Advertisement
Table of Contents
