Table of Contents
Advertisement
where:
Line 1 contains:
= module access identifier
aid
= multiframe selection [CAS | CCS]
mode
= allow Clock C selection [ON | OFF]
bypass
= zero suppression [ON | OFF]
zs
= error checking [ON | OFF]
crc
= Sync Status Messaging enabled [ON | OFF]
ssm
= bit number 4 through 8 of the Time Slot 0 word used for the E1 sync status
bit
message
Line 2 contains:
aid = module access identifier
= port signal type [ E1 | 2048], and # = port number [1 – 20]
signal#
Line 3 contains:
aid = module access identifier
= port state [ON | OFF], and # = port number [1 – 20]
pstate#
Line 4 contains:
= module access identifier
aid
squelch#
clock PQL exceeds this value, then the output is turned off. # = port number [1 –
20]
Related Commands
Set E1/2048 kHz Output
12713020-003-2 Revision F.01 – January 2007
= threshold value [0 | 1 – 16] (where 0 = disabled). If the reference
Parameters, on page 146
Chapter 2 TL1 Reference
Retrieve E1/2048 kHz Output Parameters
SSU-2000 Technical Reference
61
Advertisement
Table of Contents
