Communications Module Default Settings; Clock Module Default Settings; Communications Module Factory Default Settings; Stratum 2E And 3E Clock Module Default Settings - Symmetricom SSU-2000 Technical Reference

Chapter 8 Default Settings

Communications Module Default Settings

Communications Module Default Settings
Table 8-1 lists settings and factory defaults for the SSU-2000 Communications
Module.
Table 8-1. Communications Module Factory Default Settings
Setting
Unit Name
Module Information
configurations
User List configurations
EIA-232-C Port
Comm Port Timeout
Ethernet IP Address

Clock Module Default Settings

The Stratum 2E, TYPE I, and Stratum 3E Clock modules are software configurable
via one of the serial or Ethernet
the Clock modules.
Table 8-2. Stratum 2E and 3E Clock Module Default Settings
Setting
Warmup Time (s)
Min Lock Tau (s)
Max Lock Tau (s)
Clk Switch AR
Input Switch
348 SSU-2000 Technical Reference
SSU_2000
Current Configuration = the configuration that is currently in use.
User Default Configuration = configuration the user specifies as the
default if the current configuration is invalid or not present.
Factory Configuration = the factory default configuration
Maximum of 25 users including four built-in users.
All three comm ports are set to 9600 baud, Interactive Mode, CRLF, and
Echo on
Five minutes for all (Interactive Mode). (Note: the unit should have one
user added; that is, not in the INITUSERTABLE state). If it is in the
INITUSERTABLE state, no timeout is applied.
No Timeout is assigned for the TL1 Mode.
IP Address 0.0.0.0
Gateway Address 0.0.0.0
Network Mask 255.255.255.0
ports.Table 8-2
Factory Default
ST2E TYPE I
1200
300 150
9000 155
On
Auto Return (AR)
Factory Default
lists settings and factory defaults for
ST3E ST2E
1000 300–10 000
1200 300–10 000
AR (2) | AS On (1) | AS Off (0)
12713020-003-2 Revision F.01 – January 2007
Range
TYPE I ST3E
900 – 3600
150–1200 150–1200
150–1200 150–1200
On (1) | Off (0)