Symmetricom SSU-2000 Technical Reference page 307

Table 6-10. DS1/E1 Input Module Alarm and Event Messages (Continued)
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
134 Cannot Enable, Input
Module, COML
144 Zero Phase, B, COML
145 Rcv Pql Chg, 3, old=4
146 Phase Buildout, 334000,
335000, Clk-B
193 DS1 Framer, ESF, COML
194 E1 Framer, CCS, COML
195 Freq, 10 MHz, COML
196 ZS, On, COML
197 SSM, Off, COML
198 CRC, On, COML
199 Port, Disable, COML
200 SSM, Auto, COML
201 Priority, 5, COML
202 SSM Bit, 4, COML
203 Prov PQL, 5, COML
204 MTIE Err Limit, T100, L1,
550, COML
205 Gain, On, COML
206 CSFlt, Off, COML
207 Err Cnt, BPV, 16, COML
208 Clr Cnt, OOF, 5, COML
209 Freq Err Limit, Clk-A, 100,
COML
210 Freq Clr Limit, Clk-A, 800,
COML
211 MTIE Clr Limit, T100, L1,
500, COML
212 MTIE Limit, DS1, COML,
Setting
213 PBO, Report, COML
214 Freq Tau, Clk-A, 400, COML
12713020-003-2 Revision F.01 – January 2007
Corrective Action
Internal firmware conflict. Restart module; if the problem persists,
call Symmetricom Global Services.
User has forced the phase to be cleared.
Input has received a different PQL.
Input performed phase buildout and difference in Phase that cause
PBO.
An Input framer setup change.
An Input framer setup change.
User changed input framer setup.
User changed input framer setup.
User changed input SSM capability.
User changed CRC setup.
User Enabled | Disabled input port.
User changed SSM setup.
User changed input priority level.
User changed SSM Bit location (E1 only).
User changed input provisioned PQL.
User changed input MTIE limits (L1 | L2).
User changed the input gain control.
User changed input Cesium Fault control.
Signal Alarm Error Count (LOS, AIS, OOF, BPV, or CRC).
Current Signal Alarm Clear Count (LOS, AIS, OOF, BPV, or CRC).
The frequency error limit settings have been changed.
The frequency clear limit settings have been changed.
The MTIE error limit settings have been changed.
The MTIE clear limit settings have been changed.
Phase Build-out system response has been changed to the
indicated setting.
The frequency TAU limits have been set.
Chapter 6 Alarms and Events
DS1/E1 Input Module Alarms and Events
Description/
SSU-2000 Technical Reference 307