Retrieve E1 Lrm Parameters - Symmetricom SSU-2000 Technical Reference

Retrieve E1 LRM Parameters

This command returns the E1 Line Re-Timing Module settings.
Syntax
RTRV-PRMTR-LRME1:[tid]:[aid]:ctag;
Parameter
[aid]
Response Format
^^^"aid:enable,slip,flt" <cr lf>
where:
= module or port access identifier
aid
= module or port is enabled [ON | OFF]
enable
= slip error threshold in any 24 hour period
slip
= fault strategy [AIS | SQUELCH]. It defines Side 1 output generation when
flt
the LRU has a loss of signal on side 1 input, loss of all reference sources (PLL
unlock), or if the input signal's frequency has exceeded the LRU's ability to retime
data.
Fault
Side 1 LOS
PLL Unlock
Excessive Frequency Input
Related Commands
Set DS1 LRM
12713020-003-2 Revision F.01 – January 2007
Value
Retrieves the parameters from all E1 Line Re-Timing
ALL
Modules in the shelf.
Retrieves parameters from the specified E1 Re-Timing
SxAy[-z]
Module [or port].
CTA Installed
Fault Strategy
CTA Engaged
Fault Strategy
Parameters, on page 144
Chapter 2 TL1 Reference
Retrieve E1 LRM Parameters
Description
CTA Not Installed
Fault Strategy
Fault Strategy
Fault Strategy
SSU-2000 Technical Reference 57