Quad Ds1 Lrm; E1 Lrm Module Alarm Defaults - Symmetricom SSU-2000 Technical Reference

Table 6-18. E1 LRM Alarm and Event Messages (Continued)
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
146 Signal Path, CT/A
Disengaged, LOS
193 Port Cntl, Port[2-3], Disable,
COML
196 SlipCount, Port[2-3], 4, COML
197 BPV Err, Port[2-3], Clr, COML
198 Fault Strategy, Port[2-3],
Squelch, COML
199 Circuit ID, Set
251 Err Delay, (0), 10 sec, COML
252 Alm Level, (1), Min, COML
254 Setup, Factory, COML
Table 6-19. E1 LRM Module Alarm Defaults
ID Description
000 LOS
001 AIS
002 OOF
003 BPV
004 SLIP
005 LOS Side2
010 REF PLL
011 CT/A Fuse
12 CT/A

Quad DS1 LRM

Table 6-20 lists the alarms and events for the Quad DS1 Line Re-timing Module,
and includes the typical response for each alarm or event, it's event number, and a
description or a suggested corrective action. The SNMP MIB trap is listed in the
Alarm/Event/Trap Description column.
DS1 Line Re-timing Module alarms.
12713020-003-2 Revision F.01 – January 2007
Corrective Action
Signal is through re-timer module or cut-through
Port control on ports 2 and 3 disabled
Slip count on ports 2 and 3 set to 4
Clear BPV accumulated error count
Reference Fault Strategy for CTA Action
Port Circuit ID set
An alarm delay time change
An alarm level change
User defaults have been set and saved
Alarm Level
Table 6-21
Chapter 6 Alarms and Events
LRM Alarms and Events
Description/
lists the default parameters for the
SSU-2000 Technical Reference 317