Japan Sine Input Module Alarms And Events; Japan Sine Input Module Alarm And Event Messages - Symmetricom SSU-2000 Technical Reference

Chapter 6 Alarms and Events

Japan Sine Input Module Alarms and Events

Japan Sine Input Module Alarms and Events
Table 6-16 lists the alarms and events for the Japan Sine Input module, and
includes the ID number, a typical response for each alarm or event, and a
description or a suggested corrective action. The SNMP MIB trap is listed in the
Alarm/Event/Trap Description column.
Japan Sine Input module alarms.
Table 6-16. Japan Sine Input Module Alarm and Event Messages
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
000 LOS, Active
005 MTIE/L1, Exceeded
006 MTIE/L2, Exceeded
007 CS Fault, Fault
009 Ref Qualifier, Fault
010 Clock PLL, Fault
011 Input PLL, Fault
012 Phase Hdw, Fault
013 FREQ, Fault
014 Hdw Config, Fault
129 Install, J/SW Input Module
130 Remove, J/SW Input Module
131 Enable, J/SW Input Module,
COML
132 Disable, J/SW Input Module,
COML
133 Restart, in 5 seconds, COML
134 Cannot Enable, Input Module,
COML
144 Zero Phase, B, COML
146 Phase Buildout, 334000,
335000, Clk-B
195 Freq, 6.312 MHz, COML
199 Port, Disable, COML
314 SSU-2000 Technical Reference
Table 6-15 lists the default parameters for the
Description/
Corrective Action
Verify signal is connected. To extinguish, disable port.
MTIE limit 1 has been exceeded.
MTIE limit 2 has been exceeded.
Cesium fault
Re-seat module, or correct the input signal to clear the fault.
Re-seat module.
Verify input frequency setting. Re-seat module.
Re-seat module.
Input frequency greater than threshold. Monitor frequency; if
persistent, check source.
Input module can be installed only in the Main shelf.
If module is installed in slot previously used by a different
module type, use the CONF xAy REMOVE command.
If problem persists, call Symmetricom Global Services
The Input module has been installed.
The Input module has been removed.
The Input module has been enabled.
The Input module has been disabled.
Module re-boot.
Internal firmware conflict. Restart module; if the problem
persists, call SGS.
User has forced the phase to be cleared.
Input performed phase buildout and difference in Phase that
cause PBO.
A user has changed input framer setup.
A user has Enabled | Disabled input port.
12713020-003-2 Revision F.01 – January 2007