Ds1 Output Module Alarm Defaults - Symmetricom SSU-2000 Technical Reference

Table 6-26. DS1 Output Module Alarm and Event Messages (Continued)
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
194 ZS, On, COML
195 DS1 LEN, Port[0-5],
len=133ft, COML
199 CRC, On, COML
201 SSM Bit, 8, COML
202 Min Clk Level, ACQ, COML
203 Bypass, ON, COML
204 Squelch, Port[0-5], 0, COML
205 Delay, Port{1-4], 1375ft,
COML
224 IoName, Set
252 Alm Level, (1), Min, COML
253 Elevate Time, 86400 sec,
COML
254 Setup, User Default, COML
Table 6-27. DS1 Output Module Alarm Defaults
ID Description
000 Redundant
001 Module Match
002 Clk-A
003 Clk-B
004 Clk-C
005 Clk Level
006 Clk Selected
007 PortFlt
008 VCXO
009 PLL
010 Configuration
011 Hdw Config
012 Clk-D
12713020-003-2 Revision F.01 – January 2007
Corrective Action
User changed output framing type.
User changed output line length.
User has changed output framing type.
User has changed output SSM bit position (E1 only).
User has changed Minimum Clock Level to turn on outputs.
User has changed Bypass mode of operation
User has changed squelch PQL level.
CC signal phase offset settings have been changed for the port
shown.
User has changed the port name.
User has changed time to elevate alarm level.
An alarm elevation time change.
User has reset setup to user-defined default values.
Alarm Level
Major
Major
Major
Major
Major
Major
Major
Major
Major
Major
Major
Major
Major
Chapter 6 Alarms and Events
DS1 Output Module Alarms and Events
Description/
SSU-2000 Technical Reference 325