Ds1 And E1 Output Module Default Settings - Symmetricom SSU-2000 Technical Reference

Chapter 8 Default Settings

DS1 and E1 Output Module Default Settings

Table 8-9. DS1 Line Re-timing Module Configuration (Continued)
Configuration Setting
Slips Threshold
Fault Strategy
Port Enable
Circuit ID

DS1 and E1 Output Module Default Settings

Table 8-10 lists settings and factory defaults for the SSU-2000 DS1 and E1 Output
modules.
Table 8-10. DS1 and E1 Output Module Default Settings
Setting
Enable/Disable Outputs
Minimum Clock Level
Bypass Mode
Framing
Line Length
PQL Override
Zero Suppression
Alarm Elevation Time
356 SSU-2000 Technical Reference
Factory
Default
E1 Line Re-Timing Module
Error = 4, 1 to 255 (in any 24 hour period)
Clear <4
AIS AIS
SQUELCH
Enabled Enabled
Disabled
None (blank) String from 0-43 characters (only valid TL1 characters
are supported)
Factory
Default
DS1 Output Module
Enabled Settable for each output port
Acquire Acquire/Lock
ON ON – Clock C is selected if it is the only one available
OFF – Clock C is not selected even if no other clock is
available
ESF D4/ESF
0-133 ft 133-266 ft
266-399 ft
399-533 ft
533-655 ft
Disabled 0 | 1 – 16, 0 is disabled
ON ON – B8ZS
OFF – AMI
86 400 s 60 to 500 000 s, 0 is disabled
Range
Range
12713020-003-2 Revision F.01 – January 2007