Table of Contents
Advertisement
Chapter 6 Alarms and Events
Clock Module Alarms and Events
Table 6-2. Clock Module Alarm and Event Messages (Continued)
Alarm/
Typical Alarm/Event/Trap
Event/
Response
Trap ID
132
Module Disabled
133
Module Restarting
144
Clock Select
145
Set Software PLL
146
Input Select
147
Output PQL
148
Bypass Clock C selection
149
Acq-Sync Operation
150
Subtending
194
User Change Warmup Time
195
User Change Start TC
196
User Change Default TC
199
User Change Clock Switch
200
User Change Input Switch
201
User Change LO External
Output
202
User Change Input
Selection Mode
203
User Change Sync Speed
251
Alarm Error Delay Time
Changed
252
Alarm Level Changed
253
Elevation Time Changed
254
Setup Changed
292 SSU-2000 Technical Reference
Corrective Action
A user has disabled a Clock module.
A user has requested a reboot.
A user has selected a Clock module to be Active.
Status of the software phase-locked loop.
The identified input port is selected.
A user has changed the output PQL value.
A user has set the selected input as an output source.
The status of the sync operation.
A user has changed the operating mode.
A user has changed the oscillator warmup time setting.
A user has changed the starting Time Constant (tau).
A user has changed the default Time Constant (tau).
A user has changed the Clock Auto-Return mode.
A user has changed the Clock Auto-Switch mode.
A user has changed the Local Oscillator Output on the LO Output
connector.
A user has changed the reference selection mode.
A user has changed sync speed.
A user has changed the Alarm Delay time.
A user has changed the Alarm level.
A user has changed alarm elevation time.
A user has set the module's configuration.
Description/
12713020-003-2 Revision F.01 – January 2007
Advertisement
Table of Contents
