Table of Contents
Advertisement
Chapter 2 TL1 Reference
Set E1/2048 kHz Output Parameters
Set E1/2048 kHz Output Parameters
This command sets the output parameters for the specified E1/2048 kHz Output
module or port.
Syntax
SET-PRMTR-OUTE12048:[tid]:[aid]:ctag::[pstate],[bypass],[zs],
[signal],[squelch],[mframe],[crc],[ssm],[bit];
Parameter
aid
pstate
bypass
zs
signal
squelch
mframe
crc
ssm
bit
Empty fields leave parameters unchanged.
Related Commands
Retrieve E1/2048 kHz Output
130 SSU-2000e Technical Reference
Format
Sets the parameters for the specfied E1/2048 kHz Output
SxAy[-z]
module [or port].
Enables or disables the specified module [or port].
ON | OFF
Allows operation when Clock C is the active clock.
ON | OFF
Turns zero suppression on or off for the specified module
ON | OFF
[or port] when framed outputs are selected.
Sets the signal type on the specified module [or port].
E1 | 2048
Turns off the specified module [or port] if the reference
0 | 1 - 16
clock PQL exceeds the squelch threshold specified in
this field. 0 disables the function.
Sets the multiframe mode for the specified module [or
CAS | CCS
port].
Eanbles or disables error checking.
ON | OFF
Sets the specified module [or port] to read or ignore
ON | OFF
incoming Sync Status Messages.
Sets the bit number of the Time Slot 0 word used for the
4 - 8
E1 SSM.
Parameters, on page 54
Description
12713140-003-2 Revision E.01 – January 2007
Advertisement
Table of Contents
