Debug Fiber-Monitoring - Allied Telesis x510-28GTX Command Reference Manual

P C C
LUGGABLES AND ABLING OMMANDS
-
DEBUG FIBER MONITORING

debug fiber-monitoring

Overview Use this command to enable debugging of active fiber monitoring on the specified
ports.
Use the no variant of this command to disable debugging on all ports or the
specified ports.
Syntax debug fiber-monitoring interface <port-list>
no debug fiber-monitoring [interface <port-list>]
Default Debugging of active fiber monitoring is disabled by default.
Mode User Exec/Privileged Exec
Usage While debugging is enabled by this command for a port, all the optical power
readings for the port are sent to the console.
Example To enable debugging messages for active fiber monitoring of port 1.0.2 to be sent
to the console, use the commands:
awplus#
awplus#
To disable debugging messages for active fiber monitoring on port 1.0.2, use the
command:
awplus#
To disable all debugging messages for active fiber monitoring, use the command:
awplus#
C613-50170-01 Rev B
Parameter Description
<port-list>
The list of fiber ports to enable or disable debugging for, as a
single port, a comma separated list or a hyphenated range.
debug fiber-monitoring interface port 1.0.2
terminal monitor
no debug fiber-monitoring interface port 1.0.2
no debug fiber-monitoring
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
301