Honda ACCORD HYBRID 2005 Service Manual page 650

EVAP System
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
11. J u m p the SCS line w i t h the HDS.
12. Disconnect PCM connector B (24P).
13. Check for continuity between EVAP canister purge
valve 2P connector t e r m i n a l No. 1 and body g r o u n d .
E V A P CANISTER P U R G E V A L V E 2P C O N N E C T O R
P C S ( R E D / Y E L )
W i r e side of female t e r m i n a l s
Is there continuity?
YES—Repair short in the w i r e between the EVAP
canister purge valve and the PCM (B2), then go to
step 25.
N O — G o t o step 3 1 .
14. Turn the ignition switch OFF.
15. Disconnect the EVAP canister purge valve 2P
connector.
16. T u r n the ignition switch O N (II).
17. Measure voltage between EVAP canister purge
valve 2P connector terminal No. 2 and body g r o u n d .
E V A P CANISTER P U R G E V A L V E 2P C O N N E C T O R
IG1 ( B L K / Y E L )
W i r e side of female t e r m i n a l s
Is there battery voltage?
Y E S — G o t o step 18.
NO—Repair open in the w i r e between the EVAP
canister purge valve and the No. 18 ACG (15 A) fuse
in the under-dash fuse/relay box, then go to step 25.
18. Turn the ignition switch OFF.
19. J u m p the SCS line w i t h the HDS.
20. Disconnect PCM connector B (24P).
2 1 . Connect EVAP canister purge valve 2P connector
terminal No. 1 to body g r o u n d w i t h a j u m p e r wire.
E V A P CANISTER P U R G E V A L V E 2P C O N N E C T O R
2
P C S ( R E D / Y E L )
J U M P E R WIRE
W i r e side of f e m a l e t e r m i n a l s
11-410