Honda ACCORD HYBRID 2005 Service Manual page 1015

DTC P1717: Open in Transmission Range
Switch ATP RVS Switch Circuit
NOTE:
• Record all freeze data and review General
Troubleshooting Information (see page 14-4) before
y o u troubleshoot.
• This code is caused by an electrical circuit p r o b l e m
and cannot be caused by a mechanical p r o b l e m in the
transmission.
1. Turn the ignition switch ON (II).
2. Shift the shift lever into the R position, and verify
the A/T R SWITCH signal w i t h the HDS in the A/T
data list.
Is the A/T R SWITCH ON?
Y E S — G o t o step 3.
NO—Check the transmission range switch
installation, and adjust the shift cable (see page
14-265), then recheck. •
3. Check the REVERSE SWITCH w i t h the HDS.
Is the REVERSE SWITCH ON?
Y E S — I n t e r m i t t e n t failure, the system is OK at this
t i m e . H
N O — G o t o step 4.
4. Turn the ignition switch OFF.
5. Disconnect the transmission range switch
connector.
6. Check for continuity between transmission range
switch connector t e r m i n a l No. 5 and body g r o u n d .
T R A N S M I S S I O N R A N G E
SWITCH C O N N E C T O R
GND (BLK)
3 4
10
W i r e side of f e m a l e t e r m i n a l s
Is there continuity?
Y E S — G o t o step 7.
NO—Repair an open in the w i r e between the
transmission range switch and g r o u n d (G101,
G102), or repair a poor g r o u n d (G101, G102), then
go to step 11.
7. Turn the ignition switch ON (II).
8. Measure the voltage between t r a n s m i s s i o n range
switch connector terminals No. 5 and No. 9.
T R A N S M I S S I O N R A N G E
SWITCH C O N N E C T O R
GND (BLK)
2 3
6 7 8 9 10
4 5
ATP R V S
(RED/WHT)
Wire side of female t e r m i n a l s
Is there voltage?
Y E S — G o t o step 9.
NO—Go to step 10
(cont'd)
14-179