Honda ACCORD HYBRID 2005 Service Manual page 320

PGM-FI System
D T C T r o u b l e s h o o t i n g ( c o n t ' d )
9. Turn the ignition switch OFF.
10. J u m p the SCS line w i t h the HDS.
11. Disconnect PCM connector A (31P).
12. Check for continuity between MAP sensor 3P
connector terminal No. 2 and body g r o u n d .
MAP S E N S O R 3P C O N N E C T O R
3
MAP (GRN/RED)
W i r e side of f e m a l e t e r m i n a l s
Is there continuity?
Y E S — R e p a i r short in the w i r e between the PCM
(A11) and the MAP sensor, then go to step 15.
N O — G o t o step 20.
13. Turn the ignition switch OFF.
14. Replace the MAP sensor (see page 11-218).
15. Reconnect all connectors.
16. Turn the ignition switch ON (II).
17. Reset the PCM w i t h the HDS.
18. Do the PCM idle learn procedure (see page 11-340).
19. Check for T e m p o r a r y DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P0107 is indicated, check for poor
connections or loose terminals at the MAP sensor
and the PCM, then go to step 1. If any other
T e m p o r a r y DTCs or DTCs are indicated, go to the
indicated DTCs t r o u b l e s h o o t i n g .
NO—Troubleshooting is complete. •
20. Update the PCM if it does not have the latest
software, or substitute a k n o w n - g o o d PCM
(see page 11-6).
2 1 . Check for T e m p o r a r y DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P0107 is indicated, check for poor
connections or loose terminals a t t h e MAP sensor
and the PCM, then go to step 1. If any other
T e m p o r a r y DTCs or DTCs are indicated, go to the
indicated D T C s t r o u b l e s h o o t i n g .
NO—If the PCM w a s updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-219). •
11-80