Honda ACCORD HYBRID 2005 Service Manual page 818

IMA System
I P U L i d R e m o v a l / I n s t a l l a t i o n
NOTE: Put on gloves to protect y o u r hands f r o m
electrical shock.
IMA components are located in this area. The IMA is a
high-voltage system. You must be familiar w i t h the IMA
system before w o r k i n g on or around it. Make sure y o u
have read the IMA service precaution before doing
repairs or service (see page 12-3).
1. Remove the rear seat back, and seat cushion
(see page 20-95).
2. Turn the battery m o d u l e switch OFF (see page 12-4).
3. Remove the bolts (A).
4. Remove the IPU lid (B).
5. Install the parts in the reverse order of removal.
6. Before the battery m o d u l e switch is turned O N ,
make sure all the high voltage circuits are
connected properly. Then push the tab (A) and then
turn the battery module switch O N .
M C M R e m o v a l / I n s t a l l a t i o n
NOTE: Put on gloves to protect y o u r hands f r o m
electrical shock.
IMA components are located in this area. The IMA is a
high-voltage system. You must be familiar w i t h the IMA
system before w o r k i n g on or around it. Make sure y o u
have read the IMA service precaution before doing
repairs or service (see page 12-3).
1. Remove the IPU lid (see page 12-140).
2. Rise the harness holder. Disconnect the DC-DC
converter connector (A) and g r o u n d w i r e f r o m the
terminal (B).
3. Disconnect M C M connectors (C).
4. Remove the M C M (D).
5. Install the parts in the reverse order of removal.
6. Do the PCM idle learn procedure (see page 11-340).
7. Do the MOTOR ROTOR POSITION CALIBRATION
(see page 12-6), if the M C M has been replaced.
12-140