Honda ACCORD HYBRID 2005 Service Manual page 826

IMA System
M o t o r P o w e r C a b l e R e m o v a l / I n s t a l l a t i o n
NOTE: Put on gloves to protect your hands f r o m
electrical shock.
I M A c o m p o n e n t s are located in this area. The IMA is a
high-voltage system. Y o u must be familiar w i t h the IMA
system before w o r k i n g on or around it. Make sure y o u
have read the IMA service precaution before doing
repairs or service (see page 12-3).
1. Remove the fuel tank (see page 11-367).
2. Remove the heat shield (A).
3. Remove the IPU lid (see page 12-140).
4. Disconnect the motor power cables (A) f r o m the
MPI m o d u l e , then w r a p t h e m w i t h insulating
tape (B).
NOTE: Check the position of the U phase, V phase
and W phase cables before disconnecting the
m o t o r power cables.
9.8 N-m
(1.0 k g f m ,
7.2 Ibfft)
5. Remove the motor current sensors (see step 2 on
page 12-143).
6. Disconnect the A/C compressor power cables (A)
f r o m the terminal stay, then w r a p t h e m w i t h
insulating tape (B).
Note the position of the U phase, V phase, and
W phase cables before disconnecting the motor
power cables.
9.8 N-m
(1.0 k g f m , 7.2 Ibfft)
7. Disconnect the motor power cable connector (A)
f r o m the motor stator (B).
NOTE: Refer to disconnecting motor power cable
connector f r o m motor startor (see page 12-3).
12-148