Honda ACCORD HYBRID 2005 Service Manual page 593

66. Turn the ignition switch ON (II), and measure
voltage between fuel p u m p 5P connector terminal
No. 5 and body ground within 2 seconds.
FUEL PUMP 5P CONNECTOR
1
2
/
V
5 /
F P + (YEL/GRN)
Wire side of female terminals
Is there battery voltage?
YES—Replace the fuel p u m p (see page 11-366),
then go to step 67.
NO—Substitute a known-good fuel p u m p control
module (see page 11-370), then go to step 67 and
recheck. If DTC P0627 is not indicated, replace the
original fuel pump control module (see page
11-370), then go to step 67. If DTC P0627 is
indicated, go to step 73.
67. Turn the ignition switch OFF.
68. Reconnect all connectors.
69. Turn the ignition switch ON (II).
70. Reset the PCM w i t h the HDS.
7 1 . Do the PCM idle learn procedure (see page 11-340).
72. Check for Temporary DTCs or DTCs in the DTCs
MENU w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P0627 is indicated, check for poor
connections or loose terminals at the fuel p u m p
control module, PGM-FI main relay 2 (FUEL PUMP),
the fuel p u m p , and the PCM, then go to step 1. If
any other Temporary DTCs or DTCs are indicated,
go to the indicated DTCs troubleshooting.
NO—Troubleshooting is complete. •
73. Update the PCM if it does not have the latest
software, or substitute a known-good PCM
(see page 11-6).
74. Check for Temporary DTCs or DTCs in the DTCs
MENU w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P0627 is indicated, check for poor
connections or loose terminals at the fuel p u m p
control module, PGM-FI main relay 2 (FUEL PUMP),
the fuel p u m p , and the PCM, then go to step 1. If
any other Temporary DTCs or DTCs are indicated,
go to the indicated D T C s troubleshooting.
NO—If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 11-219). •
11-353