Honda ACCORD HYBRID 2005 Service Manual page 1036

Automatic Transmission
R o a d T e s t ( c o n t ' d )
Downshift: D Position
Accelerator pedal position sensor voltage:
1.02 V
Lock-up OFF 3 9 - 4 2 m p h ( 6 3 - 6 8 km/h)
5th — 4th 3 4 - 3 7 m p h ( 5 5 - 6 0 km/h)
4th — 3rd 2 3 - 2 5 m p h ( 3 7 - 4 0 km/h)
3rd -> 2nd 11—12 m p h ( 1 8 - 1 9 km/h)
Fully-opened throttle
Accelerator pedal position sensor voltage:
4.65 V
Lock-up OFF 1 1 5 - 1 1 9 m p h ( 1 8 5 - 1 9 2 km/h)
5th — 4th 1 2 3 - 1 2 7 m p h ( 1 9 8 - 2 0 4 km/h)
4th — 3rd
8 2 - 8 6 m p h ( 1 3 2 - 1 3 8 km/h)
3 r d — 2nd 51 - 5 5 m p h ( 8 2 - 8 9 km/h)
2nd — 1st 2 7 - 2 9 m p h ( 4 3 - 4 7 km/h)
6. Drive the vehicle in 4th or 5th gear in the D position,
then shift to the 2 position. The vehicle should
immediately begin to s l o w d o w n f r o m engine
braking.
10. Park the vehicle on a slope (about 16 °), apply the
brake, and shift into the P position. Release the
brake; the vehicle should not move.
NOTE: A l w a y s use the brake to hold the vehicle
w h e n stopped on an incline in gear. Depending on
the grade of the incline, the vehicle could roll
backwards if the brake is released.
7. Shift to the 1 position, accelerate f r o m a stop at full
throttle, and check for a b n o r m a l noise and clutch
slippage. Also check that upshifts should not occur.
8. Shift to the 2 position, accelerate f r o m a stop at full
throttle, and check for a b n o r m a l noise and clutch
slippage. Also check that upshifts and downshifts
should not occur.
9. Shift to the R position, accelerate f r o m a stop at full
throttle, and check for a b n o r m a l noise and clutch
slippage.
14-200