Honda ACCORD HYBRID 2005 Service Manual page 491

13. Disconnect the throttle body 6P connector.
14. Check for continuity between throttle actuator
control module 16P connector terminals No. 10 and
No. 12.
THROTTLE A C T U A T O R CONTROL
MODULE 16P C O N N E C T O R
1 2
/ /
A
6 7 8
9 1 0 1 1 1 2
A
1 4
/ /
TPSA
(RED/BLK)
T P S B
(RED/BLU)
Wire side of female terminals
Is there continuity?
YES—Repair short in the w i r e between the TPSA
line and the TPSB line, then go to step 17.
N O — G o t o step 15.
15. Turn the ignition switch OFF.
16. Replace the throttle body (see page 11-386).
17. Reconnect all connectors.
18. Turn the ignition switch ON (II).
19. Reset the PCM w i t h the HDS.
20. Do the PCM idle learn procedure (see page 11-340).
21. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
YES—If DTC P2135 is indicated, check for poor
connections or loose terminals at the throttle body
and the throttle actuator control module, then go to
step 1. If any other Temporary DTCs or DTCs are
indicated, go to the indicated DTCs
troubleshooting.
NO—Troubleshooting is complete. •