Honda ACCORD HYBRID 2005 Service Manual page 511

19. Turn the ignition switch OFF.
20. Replace the EOP sensor (see page 11-281).
2 1 . Reconnect all connectors.
22. Turn the ignition switch ON (II).
23. Reset the PCM w i t h the HDS.
24. Do the PCM idle learn procedure (see page 11-340).
25. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
YES—If DTC P0523 is indicated, check for poor
connections or loose terminals at the EOP sensor
and the PCM, then go to step 1. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated D T C s troubleshooting.
N O — G o t o step 26.
26. Monitor the OBD STATUS for DTC P0523 in the
DTCs MENU w i t h the HDS.
Does the screen indicate PASSED?
YES—Troubleshooting is complete. •
NO—If the screen indicates FAILED, check for poor
connections or loose terminals at the EOP sensor
and the PCM, then go to step 1. If the screen
indicates NOT COMPLETED, go to step 24 and
recheck.
27. Update the PCM if it does not have the latest
software, or substitute a known-good PCM
(see page 11-6).
28. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S - l f DTC P0523 is indicated, check for poor
connections or loose terminals at the EOP sensor
and the PCM, then go to step 1. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated D T C s troubleshooting.
NO—If the PCM was updated, troubleshooting is
complete. If the PCM was substituted, replace the
original PCM (see page 1 1 - 2 1 9 ) . •
11-271