Honda ACCORD HYBRID 2005 Service Manual page 524

Active Control Engine Mount (ACM) System
D T C T r o u b l e s h o o t i n g (cont'd)
10. Turn the ignition switch OFF.
11. Check for continuity between engine mount control
unit 20P connector terminals No. 9 (No. 1)* and
No. 20 (No. 10)*.
ENGINE MOUNT CONTROL UNIT 20P CONNECTOR
SOLRM
(GRN)*
S O L F M
( Y E L / G R N )
1 2 3 4
i—i
5 6
/
8 9
10 11 12
/
14 15 16 17
/ /
20
SOLRP
(LT B L U ) *
S O L F P
(BLU)
Wire side of female terminals
Is there continuity?
YES—Repair short in the w i r e between the engine
m o u n t control unit No. 9 and No. 20 terminals
(No. 1 and No. 10 terminals)*, then go to step 14.
N O — G o t o step 12.
12. Check the resistance between active control engine
mount (ACM) actuator 2P connector terminals
No. 1 and No. 2.
ACTIVE CONTROL ENGINE MOUNT (ACM)
ACTUATOR 2P C O N N E C T O R
1 2
Terminal side of male terminals
Is there about 0.75- 1.15 Q?
YES—Replace the engine m o u n t control unit
(see page 11 -323), then go to step 14.
NO—Replace the front engine m o u n t (see page
5-22) or rear engine m o u n t (see page 5-24), then go
to step 14.
13. Turn the ignition switch OFF.
14. Reconnect all connectors.
15. Turn the ignition switch ON (II).
11-284