Honda ACCORD HYBRID 2005 Service Manual page 1122

Automatic Transmission
T r a n s m i s s i o n D i s a s s e m b l y ( c o n t ' d )
37. Remove the ATF strainer (A).
38. Remove the accumulator body (B) (11 bolts), dowel
pins (two), detent a r m (C), arm shaft (D), and
separator plate (E).
39. Remove the ATF feed pipe (F) f r o m the main valve
body.
40. Remove the secondary valve body (G) (one bolt),
dowel pins (two), and separator plate (H). Do not let
the check balls (I) (two) fall out.
41. Remove the regulator valve body (J) (seven bolts),
stator shaft (K), stator shaft stop (L), dowel pins
(two), and separator plate (M).
42. Remove the main valve body (N) (8 m m : three bolts,
6 m m : seven bolts). Do not let the cooler check
valve (ball) (O), spring (P), and lubrication check
valve (Q) fall out.
43. Remove the torque converter check valve (R) and
valve spring (S).
44. Remove the ATF p u m p driven gear shaft (T), then
remove the ATF p u m p gears (U).
45. Remove the dowel pins (two) and main separator
plate (V).
46. Remove the ATF passage pipe (W).
47. Remove the ATF magnet (X), clean it, then reinstall.
48. Remove the O-ring (Y) f r o m the ATF strainer, and
replace the new O-ring w h e n reassembling the
transmission.
49. Remove the O-ring (Z) f r o m the stator shaft, and
replace the new O-ring w h e n reassembling the
transmission.
50. Clean the inlet opening (A) of the ATF strainer (B)
t h o r o u g h l y w i t h compressed air, then check that it
is in good condition and that the inlet opening is
not clogged.
B
5 1 . Test the ATF strainer by pouring clean ATF t h r o u g h
the inlet opening, and replace if it is clogged or
d a m a g e d .
14-286