Honda ACCORD HYBRID 2005 Service Manual page 559

10. Turn the ignition switch OFF.
11. Check for continuity between engine mount control
unit 20P connector terminals No. 9 (No. 1)* and
No. 20 (No. 10)*.
ENGINE MOUNT CONTROL UNIT 20P CONNECTOR
S O L R M
(GRN)*
S O L F M
(YEL/GRN)
1 2 3
4
i — i
5 6
/
8 9
10 11 12
/ 1 4
15 16 17
/ /
20
S O L R P
(LT B L U ) *
S O L F P
(BLU)
Wire side of female t e r m i n a l s
Is there continuity?
Y E S — R e p a i r short in the wire between the engine
m o u n t control unit No. 9 and No. 20 terminals
(No. 1 and No. 10 terminals)*, then go to step 14.
NO—Go to step 12.
12. Check the resistance between active control engine
m o u n t (ACM) actuator 2P connector terminals
No. 1 and No. 2.
ACTIVE CONTROL ENGINE MOUNT (ACM)
A C T U A T O R 2P CONNECTOR
1
2
Terminal side of male terminals
Is there about 0.75- 1.15 Q?
YES—Replace the engine mount control unit
(see page 11-323), then go to step 14.
NO—Replace the front engine m o u n t (see page
5-22) and rear engine mount (see page 5-24), then
go to step 14.
13. Turn the ignition switch OFF.
14. Reconnect all connectors.
15. Turn the ignition switch ON (II).
16. Reset the PCM w i t h the HDS.
17. Do the PCM idle learn procedure (see page 11-340).
18. Do the ACM ACTIVATION w i t h VTEC in the
INSPECTION MENU w i t h the HDS.
19. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S — I f DTC P16C6 indicated, check for poor
connections or loose terminals at the engine mount
control unit and the active control engine mount
(ACM) actuator, then go to step 1. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated DTCs troubleshooting.
NO—Troubleshooting is complete. •
11-319