Honda ACCORD HYBRID 2005 Service Manual page 733

Is there continuity?
Y E S — G o t o step 14.
NO—Repair open in the w i r e between the W phase
motor current sensor and the M C M (A28), then go
to step 4 1 .
14. Reconnect M C M connector A (31P).
15. Connect W phase motor current sensor 3P
connector terminals No. 1 and No. 3 w i t h a j u m p e r
wire.
W PHASE MOTOR C U R R E N T S E N S O R
3P C O N N E C T O R
1 2
3
VCCIW (WHT/GRN) IWPH (GRN)
J U M P E R WIRE
Wire side of female t e r m i n a l s
16. Turn the ignition switch ON (II).
17. Check the W PHASE MOTOR CURRENT SENSOR in
the DATA LIST w i t h the HDS.
Is about 0.15 V or less indicated?
YES — G o to step 47.
NO—Replace the W phase motor current sensor
(see page 12-143), then go to step 4 1 .
18. Turn the ignition switch OFF.
19. Disconnect M C M connector A (31P).
20. Check for continuity between W phase motor
current sensor 3P connector terminal No. 1 and
M C M connector terminal A16.
MCM CONNECTOR A (31P)
VCCIW (WHT/GRN)
1 2 | 3 4 5 6 7 8 9
10 11 12 13 14 15 16 17 18 19 20 21
22 23 24 25 26 27 28 29 30 31
Wire side of female
terminals
W PHASE MOTOR CURRENT ( Q )
SENSOR 3P CONNECTOR
VCCIW (WHT/GRN)
2 3
Wire side of female terminals
Is there continuity?
Y E S — G o t o step 47.
NO—Repair open in the w i r e between the W phase
motor current sensor and the M C M (A16), then go
to step 4 1 .
2 1 . Turn the ignition switch OFF.
22. Turn the battery module switch OFF (see page 12-4).
23. Remove the IPU lid (see page 12-140).
24. Disconnect the U phase m o t o r current sensor 3P
connector.
25. Turn the ignition switch ON (II).
26. Reset the M C M (see page 12-8).
27. Check for Temporary DTCs or DTCs w i t h the HDS.
Are DTC P05AE, P0A61 and P0A64 indicated at
the same time?
YES—Go to step 28.
NO—Replace the U phase motor current sensor
(see page 12-143), then go to step 4 1 .
28. Turn the ignition switch OFF.
29. Disconnect the V phase motor current sensor 3P
connector.
(cont'd)
12-55