Honda ACCORD HYBRID 2005 Service Manual page 819

J u n c t i o n B o a r d R e m o v a l / I n s t a l l a t i o n
NOTE: Put on gloves to protect your hands f r o m
electrical shock.
IMA c o m p o n e n t s are located in this area. The IMA is a
high-voltage system. You must be familiar w i t h the IMA
system before w o r k i n g on or around it. Make sure you
have read the IMA service precaution before doing
repairs or service (see page 12-3).
1. Remove the IPU lid (see page 12-140).
2. Remove the busbars (A).
3. Remove the high voltage cables (A), then w r a p
t h e m w i t h insulating tape (B).
4. Disconnect the high voltage contactor connector
(C), and bypass contactor terminals (D).
5. Disconnect the battery current sensor connector (E),
and A/C compressor driver wires (F).
6. Remove the bolts.
7. Remove the junction board (G).
8. Install the parts in the reverse order of removal.
12-141