Honda ACCORD HYBRID 2005 Service Manual page 477

17. Check for continuity between throttle actuator
control module 16P connector terminals No. 1 and
No. 8.
THROTTLE A C T U A T O R C O N T R O L
MODULE 16P C O N N E C T O R
M + (BLU)
M— (GRN)
1 2
/ / /
6 7 8
9 1 0 1 1 1 2
/
14
Wire side of female terminals
24. Test-drive the vehicle for several minutes in the
range of the recorded freeze data.
25. Check for Temporary DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
YES—If DTC P2101 is indicated, check for poor
connections or loose terminals at the throttle body
and the throttle actuator control module, then clean
the throttle body (see page 11-381), and go to step
1. If any other Temporary DTCs or DTCs are
indicated, go to the indicated D T C s
troubleshooting.
NO—Troubleshooting is complete. •
Is there continuity?
YES—Substitute a known-good throttle actuator
control module (see page 11-265), then go to step
20 and recheck. If DTC P2101 is not indicated,
replace the original throttle actuator control
module (see page 11-265), then go to step 20. If
DTC P2101 is indicated, g o t o step 18.
NO—Repair open in the wires between the throttle
body and the throttle actuator control module
(motor drive lines), then go to step 20.
18. Turn the ignition switch OFF.
19. Replace the throttle body (see page 11-386).
20. Reconnect all connectors.
21. Turn the ignition switch ON (II).
22. Reset the PCM with the HDS.
23. Do the PCM idle learn procedure (see page 11-340).
11-237