Honda ACCORD HYBRID 2005 Service Manual page 165

13. Connect the fuel feed hose (see page 11-362), then
install the quick-connect fitting cover (A).
14. Install the purge joint (A) to the bracket, then install
the evaporative emission (EVAP) canister hose (B).
15. Install the front w a r m up three w a y catalytic
converter (front WU-TWC) (see page 11-390) and
rear w a r m up three w a y catalytic converter (rear
WU-TWC) (see page 11-391).
16. Install the t i m i n g belt (see page 6-19).
17. Adjust the valve clearance (see page 6-10).
18. Install the cylinder head covers (see page 6-33).
19. Install the intake m a n i f o l d (see page 9-5).
20. Install the A/C compressor belt (see page 21-100).
2 1 . After installation, check that all tubes, hoses, and
connectors are installed correctly.
22. Inspect for fuel leaks. Turn the ignition switch
ON (II) (do not operate the starter) so the fuel p u m p
runs for about 2 seconds and pressurizes the fuel
line. Repeat this operation t w o or three times, then
check for fuel leakage at any point in the fuel line.
23. Refill the radiator w i t h engine coolant, and bleed
air f r o m the cooling system w i t h the heater valve
open (see step 8 on page 10-7).
24. Inspect the idle speed (see page 11-339).
25. Inspect the ignition t i m i n g (see page 4-21).
6-63