Honda ACCORD HYBRID 2005 Service Manual page 1029

(30
9. Check for continuity between ATFP control unit
connector t e r m i n a l No. 6 and ATFP motor
connector t e r m i n a l No. 2.
ATFP C O N T R O L UNIT
C O N N E C T O R
ATFP MOTOR
C O N N E C T O R
1 2
3
E O P - W
(RED/BLK)
EOP-W (RED/BLK)
W i r e side of female t e r m i n a l s
11. Clear the DTC w i t h the HDS.
12. W a r m up the engine to n o r m a l operating
temperature (the radiator fan comes on).
13. Drive the vehicle in the D position. Slow d o w n and
stop the wheels in auto idle stop.
14. Monitor the OBD status for P1904 in the DTCs/
Freeze Data in A/T Mode Menu for a pass/fail.
Does the result indicate a pass?
YES—The problem has been corrected. •
NO—Return to step 6 and recheck.
Is there continuity?
Y E S — G o t o step 10.
NO—Repair an open in the w i r e between ATFP
control unit connector terminal No. 6 and the ATFP
motor connector, then go to step 1 1 .
10. Check for continuity between ATFP m o t o r
connector terminals No. 1 and No. 2.
ATFP MOTOR C O N N E C T O R
EOP-V
-1 2 -
3
EOP-W
Terminal side of male t e r m i n a l s
Is there continuity?
YES—Replace the ATFP control unit (see page
14-229), then g o t o step 11.
NO—Replace the ATFP (see page 14-228), then go
to step 11.
14-193