Honda ACCORD HYBRID 2005 Service Manual page 160

Cylinder Head
Camshaft, Rocker Arm, Camshaft Seal, and Pulley Installation (cont'd)
10. Install the injector base (A). A l w a y s use a new
gasket (B).
8 x 1.25 m m
22 N m (2.2 kgf-m, 16 Ibfft)
11. A p p l y new engine oil t o the threads of the camshaft
pulley m o u n t i n g bolt (A). Install the back cover (B),
then install the camshaft pulley (C).
12 x 1.25 m m
90 N m
(9.2 kgf m
#
67 Ibfft)
8 x 1.25 m m
22 N-m
(2.2 kgf-m, 16 Ibfft)
REAR
1. Reassemble the rocker a r m assembly (see page
6-44).
2. Loosen the valve adjusting screws.
3. A p p l y a light coat of n e w engine oil around the
camshaft oil seal.
4. Gently tap the new camshaft oil seal (A) into the
cylinder head.
- 1 Tap the camshaft oil seal in squarely.
- 2 Install the oil seal about 0.5—1.5 m m
(0.02—0.06 in.) b e l o w the surface of the
cylinder head.
8 x 1.25 m m
22 N-m
(2.2 kgf m,
16 Ibfft)
5. Insert the camshaft (B) into the cylinder head, then
install the camshaft thrust cover (C). A l w a y s use a
new O-ring (D). A p p l y n e w engine oil t o the
camshaft journals and lobes.
6. Check that the oil seal lips are not distorted.
6-58