Honda ACCORD HYBRID 2005 Service Manual page 515

Check the oil pressure. 17. Monitor the OBD STATUS for DTC P2647 in the
DTCs M E N U w i t h the HDS.
Does the oil pressure increase to 392 kPa
(4.0kgf/cm 2 , 56.9 psi)?
Does the screen indicate PASSED?
YES—Replace the EOP sensor (see page 11-281),
then go to step 10.
Y E S — T r o u b l e s h o o t i n g is c o m p l e t e . •
10. Turn the ignition switch OFF.
NO—Replace the VTEC solenoid valve (see page
11-280), then go to step 10.
NO—If the screen indicates FAILED, check for poor
connections or loose terminals at the EOP sensor
and the PCM, then go to step 1 and recheck. If the
screen indicates NOT COMPLETED, go to step 15
and recheck.
11. Reconnect all connectors.
12. Turn the ignition switch ON (II).
13. Reset the PCM w i t h the HDS.
14. Do the PCM idle learn procedure (see page 11-340).
15. Start the engine. Hold the engine speed at
3,000 rpm w i t h o u t load (in Park or neutral) until the
radiator fan comes o n , then let it idle for 2 minutes.
16. Check for T e m p o r a r y DTCs or DTCs w i t h the HDS.
Are any Temporary DTCs or DTCs indicated?
Y E S - l f DTC P2647 is indicated, check for poor
connections or loose terminals at the VTEC
solenoid valve, the EOP sensor, and the PCM, then
go to step 1. If any other T e m p o r a r y DTCs or DTCs
are indicated, go to the indicated D T C s
t r o u b l e s h o o t i n g .
N O — G o t o step 17.
11-275