Honda ACCORD HYBRID 2005 Service Manual page 1101

S h i f t C a b l e A d j u s t m e n t
1. Remove the center console (see page 20-62).
2. Shift the transmission into the R position.
3. Remove the nut securing the shift cable end.
4. Press the holder lock release (A), and pull out the
socket holder (B) to remove the shift cable (C) f r o m
the shift lever bracket base (D). Do not remove the
shift cable by pulling the shift cable guide (E) and
damper (F).
5. Push the shift cable until it stops, then release it.
Pull the shift cable back one step so that the shift
position is in R. Do not hold the shift cable guide (A)
and d a m p e r (B) to adjust the shift cable (C).
6. Turn the ignition switch ON (II), and verify that the
R position indicator comes o n .
7. Turn the ignition switch OFF.
8. Place the shift lever in the R position, then insert a
6.0 m m (0.24 in.) pin (A) t h r o u g h the positioning
hole (B) on the shift lever bracket base, t h r o u g h the
positioning hole on the shift lever, and into the
positioning hole on the shift lever bracket base. The
shift lever is secured in the R position.
B A
(cont'd)
14-265