Camshaft, Rocker Arm, Camshaft Seal, And Pulley Installation - Honda ACCORD HYBRID 2005 Service Manual

Camshaft, Rocker Arm, Camshaft Seal, and Pulley Installation
FRONT
1. Reassemble the rocker a r m assembly (see page
6-43).
2. A p p l y a light coat of oil around the camshaft oil
seal.
3. Gently tap the n e w camshaft oil seal (A) into the
cylinder head.
- 1 Tap the camshaft oil seal in squarely.
- 2 Install the oil seal about 0.5—1.5 m m
(0.02—0.06 in.) below the surface of the
cylinder head.
8 x 1.25 m m
22 N m
(2.2 k g f m ,
16 Ibf-ft)
4. Insert the camshaft (B) into the cylinder head, then
install the camshaft thrust cover (C). A l w a y s use a
new O-ring (D).
5. Check that the oil seal lips are not distorted.
6. Install the solid dowel pins (E) and the h o l l o w
d o w e l pins (F).
7. Loosen the valve adjusting screws.
8. Set the rocker a r m assembly in place, and loosely
install the bolts. Make sure that the rocker arms are
properly positioned on the valve stems.
9. Tighten each bolt t w o turns at a t i m e in the
sequence s h o w n to ensure that the rockers do not
bind on the valves.
Specified Torque
8 x 1.25 mm: 24 N-m (2.4 k g f m , 17 Ibf-ft)
(cont'd)
6-57