Honda ACCORD HYBRID 2005 Service Manual page 1081

12. Install the new set ring (A) on the intermediate shaft
(B), and install the intermediate shaft in the
differential. W h i l e installing the intermediate shaft
in the differential, be sure not to allow dust or other
foreign particles to enter the transmission.
8 x 1.25 m m
26 N m
(2.6 k g f m , 20 Ibfft)
13. Install the exhaust manifold bracket (C) and heat
shield (D).
14. Install the n e w set ring on the left driveshaft, then
install the left driveshaft in the differential
(see page 16-18). While installing the driveshaft in
the differential, be sure not t o allow dust or other
foreign particles to enter the transmission. Install
the right driveshaft on the intermediate shaft.
NOTE: Turn the right and left steering knuckle fully
o u t w a r d , and slide the driveshaft and intermediate
shaft into the differential and intermediate shaft
until y o u feel its set ring engage the side gear.
15. Support the front subframe (A) w i t h the front
subframe adapter (VSB02C000016) and a jack, and
lift it up to the body.
16. Loosely install the new subframe m o u n t i n g bolts
(A), n e w rear stiffener m o u n t i n g bolts (B), f r o n t
stiffener m o u n t i n g bolts (C).
(10.5 k g f m , 1 2 x 1 . 2 5 m m 54 N-m
75.9 Ibfft)
93 N m
(5.5 kgf-m,
Replace.
(9.5 k g f m , 69 Ibfft)
40 Ibfft)
Replace.
(cont'd)
14-245