Honda ACCORD HYBRID 2005 Service Manual page 589

38. Check for continuity between PCM connector
terminal D15 and body ground.
PCM CONNECTOR D (17P)
1 2
/
4 5 6
/
8 9 10 11 12
13 14
15 16 17
FPCD (PNK)
Wire side of female terminals
Is there continuity?
Y E S — G o t o step 39.
NO—Repair open in the w i r e between the PCM
(D15) and the fuel p u m p control module, then go to
step 67.
39. Remove the jumper wire f r o m the fuel p u m p
control module 10P connector.
40. Reconnect the fuel p u m p control module 10P
connector and PCM connector D (17P).
41. Turn the ignition switch ON (II), and measure
voltage between PCM connector terminal D15 and
body ground w i t h i n 2 seconds.
PCM CONNECTOR D (17P)
1 2
/
4 5 6
/
8 9 10 11 12
13 14
15 16 17
FPCD (PNK)
®
Wire side of female terminals
Is there about 8 V or more?
Y E S — G o t o step 42.
NO—Replace the fuel p u m p control module
(see page 11-370), then go to step 67.
42. Turn the ignition switch OFF.
43. Remove the trunk floor t r i m panel.
44. Remove the access panel f r o m the floor.
45. Disconnect the fuel p u m p 5P connector.
(cont'd)
11-349