Honda ACCORD HYBRID 2005 Service Manual page 98

Engine Assembly
E n g i n e I n s t a l l a t i o n ( c o n t ' d )
53. Reinstall the support strut bracket w i t h the bolts in
the proper location.
54. Install the air cleaner housing assembly (see page
11-382).
55. Install the front grille cover (see step 1 on page
20-111).
56. Install the battery. Clean the battery posts and
cable terminals w i t h sandpaper, then assemble
t h e m . A p p l y grease to prevent corrosion.
57. Move the shift lever to each gear, and verify that
the A/T gear position indicator f o l l o w s the
transmission range switch.
58. Inspect for fuel leaks: Turn the ignition switch
ON (II) (do not operate the s t a r t e r ) so the fuel p u m p
runs for about 2 seconds and pressurizes the fuel
line. Repeat this operation t w o or three times, then
check for fuel leakage at any point in the fuel line.
59. Refill the engine w i t h engine oil (see step 4 on page
8-7).
60. Refill the transmission w i t h ATF (see page 14-231).
62. Do the powertrain control module (PCM) reset
procedure (see page 11-4).
63. Do the crankshaft position (CKP) pattern clear/ CKP
pattern learn procedure (see page 11-4).
64. Do the m o t o r rotor position calibration (see page
12-6).
65. Inspect the idle speed (see page 11-339).
66. Inspect the ignition t i m i n g (see page 4-21).
67. Enter the anti-theft codes for the radio and the
navigation system, then enter the c u s t o m e r ' s audio
presets.
68. Do the power w i n d o w control unit reset procedure
(see page 22-200).
69. Set the clock.
70. If the IMA battery level gauge (BAT) displays no
segments, start the engine, and hold it between
3,500 r p m and 4,000 r p m w i t h o u t load (in Park or
neutral) until the BAT displays at least three
segments.
6 1 . Refill the radiator w i t h engine coolant, and bleed
air f r o m the cooling system w i t h the heater valve
open (see step 8 on page 10-7).
5-20