NEC UNIVERGE SV8100 Features & Specifications Manual page 1140

Issue 5.0
Program
Number
22-15-06
22-15-07
24-02-03
25-01-02
25-02-01
25-03-01
1 - 1130
Program Name
VRS Delayed Message for
Department Group – Tone Kind
at Message Interval
VRS Delayed Message for
Department Group – Disconnect
Time After the End of VRS
Waiting Message
System Options for Transfer –
Delayed Call Forwarding Time
VRS/DISA Line Basic Data Setup
– DISA User ID
DID/DISA VRS Message
VRS/DISA Transfer Ring Group
With Incorrect Dialing
Description/Comments
For each Department Group,
determine what the caller hears
between messages (0 = Ringback
Tone, 1 = MOH, 2 = BGM). This
program is also used for VRS
Waiting Message.
For each Department Group, set
how long the system waits after
playing the VRS message before
disconnecting the call (0~64800
seconds). To prevent the call from
disconnecting, set this option to
"0". This program is also used for
VRS Waiting Message.
Set how long a telephone rings
before the call reroutes to the
programmed destination.
Select whether or not the DISA
User ID is to be used.
For each Night Service mode,
enter 1 at the "Talkie" prompt if
trunk should be automatically
answered by VRS and the
message number the caller should
hear (1~100).
Set the destination that Automated
Attendant (OPA) calls ring if the
OPA caller dials an incorrect
extension number. This also sets
the options for DISA calls. The
system allows Ring Groups or
Disconnect = 0.
Voice Response System (VRS)
UNIVERGE SV8100
Assigned Data
0 = Ring Back Tone
1 = MOH Tone
2 = BGM Source
(default = 0)
0 = No Disconnect
1~64800 Seconds
(default = 60 seconds)
0~64800 (seconds)
(default = 10)
0 = Off
1 = On
(default = 1)
0 = No Message
1 = 01~100 (VRS
Messages)
2 = 01~4 (ACI Group
Number)
3 = 01~64 (Extension
Group Number)
(default = 0)
Ring Groups:
1~100
Trunk Ports:
001~200
Day/Night Mode:
1~8
0 (Disconnect)
1~100 (Incoming Ring
Group)
102 (In-Skin/External
Voice Mail or InMail)
(default = 0)
104 (Speed Dial table
Program 25-15-01)
Version 3 software or
higher is required.
(default = 0)