Mirror Port Commands; Port Monitor; Table 4-43. Mirror Port Commands - Hirschmann GigaLION-24TP User Manual

4
Command Line Interface
Field
Ingress rule
Acceptable frame type
Native VLAN
Priority for untagged traffic Indicates the default priority for untagged frames (page 4-189).
Gvrp status
Allowed Vlan
Forbidden Vlan

Mirror Port Commands

This section describes how to mirror traffic from a source port to a target port.
Command

port monitor

show port monitor
port monitor
This command configures a mirror session. Use the no form to clear a mirror
session.
Syntax
port monitor interface [rx | tx | both]
no port monitor interface
• interface - ethernet unit/port (source port)
- unit - Switch (unit 1).
- port - Port number.
• rx - Mirror received packets.
• tx - Mirror transmitted packets.
• both - Mirror both received and transmitted packets.
Default Setting
No mirror session is defined. When enabled, the default mirroring is for both
received and transmitted packets.
Command Mode
Interface Configuration (Ethernet, destination port)
4-134
Table 4-42. interfaces switchport - display description
Description
Shows if ingress filtering is enabled or disabled (page 4-175).
Shows if acceptable VLAN frames include all types or tagged frames only
(page 4-174).
Indicates the default Port VLAN ID (page 4-176).
Shows if GARP VLAN Registration Protocol is enabled or disabled (page 4-186).
Shows the VLANs this interface has joined, where "(u)" indicates untagged and
"(t)" indicates tagged (page 4-177).
Shows the VLANs this interface can not dynamically join via GVRP (page 4-178).

Table 4-43. Mirror Port Commands

Function
Configures a mirror session
Shows the configuration for a mirror port
Mode Page
IC 4-134
PE 4-135