Access Rules - Spectracom SecureSync 1200 User Reference Manual

2.14 Configuring Network Settings

2.14.5 Access Rules

Network access rules restrict access to only those assigned networks or nodes defined. If no
access rules are defined, access will be granted to all networks and nodes.
To configure
1.
Navigate to the MANAGEMENT > Network Setup screen.
2.
In the Actions panel on the left, click on Access Control.
3.
The Network Access Rules window displays:
4.
In the Allow From field, enter a valid IP address. It is not possible, however, to add dir
ect IP addresses, but instead they must be input as blocks, i.e. you need to add
the end of an IP address to ensure that only that address is allowed.
Example:
5.
Click the Add button in the Action column to add the new rule.
6.
The established rule appears in the Network Access Rules window.
60
Note: In order to configure Access Rules, you need ADMINISTRATOR rights.
a new, or delete an existing access rule:
10.2.100.29/32
I P a d d r e s s n o m e n c l a t u r e :
IPv4— , where
10.10.0.0/16
mask in prefix form. See the table
mask values.
will allow only
10.2.100.29
is the IP address and
10.10.0.0
"Subnet Mask Values" on page 52
CHAPTER •
2 SecureSync User Reference Guide Rev. 23
at
/32
access.
is the subnet
16
for a list of subnet