Ntp Peers: Adding, Configuring, Removing - Spectracom SecureSync 1200 User Reference Manual

2.15 Configuring NTP
5.
Click Submit, or press Enter.

2.15.8.3 NTP Peers: Adding, Configuring, Removing

To add, configure, or remove an NTP Peer:
1.
Navigate to MANAGEMENT > NETWORK: NTP Setup .
2.
The NTP Setup screen appears. The NTP Peers panel displays a list of recognized NTP
peers.
3.
The NTP Peers edit window opens:
104
Note: When you configure NTP Autokey, you must first disable the
NTP service in the
Autokey configuration is completed.
Enable Burst : This tells NTP to send a burst to the remote server when the server is
reachable.
Enable Iburst : This tells NTP to send a burst to the remote server when the server is
not reachable.
Mark as Preferred : Click here to make this server the preferred server. For more
information, see "Configuring "NTP Stratum 1" Operation" on page 97.
Note: It is not normally recommended to select more than one NTP
Server in the NTP Servers table as being
one NTP server should be selected as
Note: Should the list be empty, no servers have been added yet. In the
event that added peers are not displayed, they could not be resolved.
Verify the IP address
To EDIT the settings of an NTP Peer, click the GEAR button next to it, and proceed
to Step 3 below.
To ADD a new NTP Peer, click the PLUS icon in the top right corner of the NTP
Peers panel.
To REMOVE an NTP Peer (and its associated configurations), click the X-button
next to it.
NTP Services panel, and then re-enable it after the
Preferred
CHAPTER •
2 SecureSync User Reference Guide Rev. 23
Preferred . Typically, only
.