Spectracom SecureSync 1200 User Reference Manual page 223

a): ADDING a PTP Slave
To add and configure a new PTP Slave:
1.
2.
3.
CHAPTER •
3 SecureSync User Reference Guide Rev. 23
Navigate to PTP Setup screen via MANAGEMENT > NETWORK > PTP Setup .
In the PTP Slaves panel, click the PLUS icon in the top right corner.
The Add Source pop-up window displays. Fill in the applicable parameter values:
PTP Client Version : Ver.1 or Ver.2
PTP Server : The address of the PTP server (this field will be populated by
TimeKeeper, if only one server has been configured).
PTP Domain : Determines which domain the PTP server will broadcast on. [Range:
0-255; default-suggested domain for PTP1: 0]
Low Quality Source : Check this box to improve tracking of low quality sources,
such as NTPd. [Default: Checked]
Unicast Delay Requests
this box if you would like the PTP Master to provide unicast delay responses, no
matter if the client provided a unicast or a multicast delay request. When the box
is unchecked, the server will respond with the same type of message as the
request, that is a multicast response for a multicast request, and a unicast response
for a unicast request. [Recommended setting: Unchecked]
Use Transparent Clock Corrections
parent clock correction provided with PTP data. [Default: Checked]
: Enables unicast delay requests back to the server. Check
: Check to allow the slave to apply the trans
3.6 Managing TimeKeeper
207