Dis-/Enabling Ntp - Spectracom SecureSync 1200 User Reference Manual

Other NTP Services that can be configured via the NTP Services panel by clicking the GEAR
icon are:
The NTP Status Summary panel
... provides a real-time overview of your key NTP network parameters. For more information,
see "NTP Status Monitoring" on page 274.

2.15.3 Dis-/Enabling NTP

If you applied NTP configuration changes e.g., added a new NTP Server, SecureSync usually
will stop and re-start the NTP Service automatically once you clicked Submit. Changes made to
NTP configurations will also take effect after SecureSync is either rebooted or power-cycled.
You can, however, also disable or enable the SecureSync NTP Service manually, e.g. with NTP
Autokey.
To disable and enable your NTP Service:
1.
2.
CHAPTER •
2 SecureSync User Reference Guide Rev. 23
NTP ON/OFF : This switch enables and disables NTP. See "Dis-/Enabling NTP" below.
Note: When applying any changes NTP will usually restart automatically.
Use this switch only to force a restart.
Expert Mode : Turning this switch ON enables direct access to the NTP.conf file, thus
bypassing the SecureSync Web UI. [Default =OFF] See "NTP Expert Mode" on
page 127.
Note: Spectracom Tech Support does not support the editing of the NTP
configuration files in Expert Mode. For additional information on editing
the NTP.conf file, please refer to
Autokey (see "Configuring NTP Autokey" on page 108)
Stratum 1 (see "NTP Reference Configuration" on page 97)
Navigate to MANAGEMENT > NETWORK: NTP Setup .
In the NTP Services panel, set the ON/OFF toggle switch to OFF.
2.15 Configuring NTP
http://www.ntp.org
.
93