Spectracom SecureSync 1200 User Reference Manual page 64

2.12 Setting up an IP Address
Step-by-step instructions:
A.
First, disable DHCP:
B.
Then, enter IP Address and Subnet Mask :
C.
Lastly, enter the Gateway Address (if required)
After all addresses are entered, press the
should now resemble the following example:
48
1.
Press the key.
ü
2. Using the arrow key, select
(To select a menu item, highlight it using the arrow keys, then press the ü key.)
3. Select the Ethernet interface for which DHCP is to be disabled, such as
4. Select from the next menu. The display will show
DHCP
Action=Disabled
(The State is the current DHCP setting and the Action is the action to take. You can
only change the Action setting.)
5.
Press the key once to select the action, then again to apply it.
ü
1. Still on the
Home > Netv4 > eth[0-3]
change "
N=010.010.201.001/16
subnet mask/network bits to be assigned (for a list of subnet mask values refer to
the table "Subnet mask values" on page 52).
2.
Press the key once to enter the setting, then again to apply the new setting.
ü
1. Still on the
Home > Netv4
Netv4 > eth0 > Gateway
2.
Press the key once to enter the setting, then again to apply the new setting.
ü
3.
The display will
N=000.000.000.001. Enter the gateway address here.
The address entered must correspond to the same network IP address assigned to
SecureSync.
from the menu.
Netv4
.
menu, select
" to the value of the static IP address and
menu, select the
).
change, allowing you
key three times to return to the main display. It
x
CHAPTER •
2 SecureSync User Reference Guide Rev. 23
.
eth0
and
State=Enabled
, and
IP Address
option (
Gateway Home >
to input an address at