Spectracom SecureSync 1200 User Reference Manual page 73

CHAPTER •
2 SecureSync User Reference Guide Rev. 23
Static IPv4 Address : This is the unique address assigned by the net
work administrator. The default static IP address of the SecureSync
unit is 10.10.201.1. In the format "
oes or spaces, where each '
[0,255].
Table 2-3:
Default IP addresses
Default "static lease"
ETH port
IP address
ETH0 10.10.201.1
ETH1 10.10.201.2
ETH2 10.10.201.3
ETH3 10.10.201.4
The default subnet is: 255.255.0.0
Netmask : This is the network subnet mask assigned by the network
administrator. In the form "
Mask Values" on page 52 for a list of subnet mask values.
IPv4 Gateway : The gateway (default router) address is needed if
communication to the SecureSync is made outside of the local net
work. By default, the gateway is disabled.
DNS Primary : This is the primary DNS address to be used for this
port.
Depending on how your DHCP server is configured, this is set auto
matically once DHCP is enabled. Alternatively, you may configure
your DHCP server to NOT use a DNS address.
When DHCP is disabled, DNS Primary is set manually, using the
format " " with no leading zeroes or spaces, where each
#.#.#.#
' ' is a decimal integer from the range [0,255].
#
2.14 Configuring Network Settings
" with no leading zer
#.#.#.#
' is a decimal integer from the range
#
." See "Subnet
xxx.xxx.xxx.xxx
57