Configuring Timekeeper Ptp Slaves - Spectracom SecureSync 1200 User Reference Manual

3.6 Managing TimeKeeper
3.
The Edit PTP Master pop-up window displays. Edit the desired configuration parameter
(s). For additional information, see Procedure a): "ADDING a PTP Master" above.
4.
Click Submit , and wait for the screen to refresh (TimeKeeper will be restarted).
c): DELETING a PTP Master
To delete a previously created PTP Master:
1.
Navigate to the PTP Setup screen via MANAGEMENT > NETWORK > PTP Setup .
2.
Click the X-button next to the PTP Master you wish to delete.
3.
Click OK in the pop-up window to confirm the deletion of the PTP Master, and wait for
the screen to refresh.
Next, you may want to configure TimeKeeper PTP Slaves, see "Configuring TimeKeeper PTP
Slaves" below.
3.6.4

Configuring TimeKeeper PTP Slaves

TimeKeeper is configured in the SecureSync Web UI, under MANAGEMENT > PTP Setup .
PTP Slaves are used in a network to listen for synchronization packets from PTP Masters, and
send out synchronization requests, as well as follow ups. The timing information from PTP mas
ters are used by the system as a synchronization source if NTP is an entry in the reference pri
ority table (it is by default), and no other reference set as a higher priority is available for
synchronization. No configuration is required other than setting up PTP Slaves.
To configure a PTP Slave under TimeKeeper, follow the corresponding procedure described
below:
Procedure a): ADDING a PTP Slave
Procedure b): EDITING a PTP Slave
Procedure c): DELETING a PTP Slave
206
CHAPTER •
3 SecureSync User Reference Guide Rev. 23