Spectracom SecureSync 1200 User Reference Manual page 510

APPENDIX
Command
gpsmdl
gpssat
gw4get
gw4set
gw6get
gw6set
halt
helpcli
hostget
hostset
hotstart
ip4get
ip4set
ip6add
ip6del
ip6get
iptables
licenses
list
loadconf
localget
locallist
localset
model
net
netnum
net4
net6
494
Displays the GNSS Manufacturer and Model
Displays GNSS satellites tracked and maximum signal strength being received
Displays IPv4 gateway addresses
Used to configure the IPv4 gateway addresses
Displays IPv6 gateway address
Used to configure the IPv6 gateway address
Used to Halt the system for shutdown
Provides list of available commands and syntax
Displays the DNS hostname
Sets the DNS hostname
Initiate a hot start operation on the SAASM GPS receiver
Displays IPv4 Ethernet port information (IP address net mask and gateway)
Used to set IPv4 Ethernet port information (IP address net mask and gateway)
Used to add IPv6 Ethernet port information (IP address net mask and gateway)
Used to delete IPv6 IP address
Used to obtain the IPv6 IP address
See "Network Services" on page 58
Displays configured licenses installed (if any)
Outputs a list of commands
Restore a saved configuration and reboot
Used to obtain the configured local clock
Used to display local clocks
Used to configure local clocks
Displays the Serial Number of the unit
Displays network settings
Displays the number of general-purpose network interfaces
Displays IPv4 network settings
Displays IPv6 network settings
Description
for more information.
SecureSync User Reference Guide