Spectracom SecureSync 1200 User Reference Manual page 50

2.5 SAFETY
34
DANGER! — INSTALLATION OF EQUIPMENT:
Installation of this product is to be done by authorized service personnel
only. This product is not to be installed by users/operators without legal author
isation.
Installation of the equipment must comply with local and national electrical codes.
DANGER! — DO NOT OPEN EQUIPMENT, UNLESS AUTHORIZED:
The interior of this equipment does not have any user serviceable parts. Contact
Spectracom Technical Support if this equipment needs to be serviced. Do not
open the equipment, except to retrofit option cards, or replacement of battery. Fol
low Spectracom Safety Instructions, and observe all local electrical regulatory
requirements.
IF THE EQUIPMENT MUST BE OPENED:
Never remove the cover or blank option card plates with power applied to this
equipment. Ensure all power sources are removed from the unit prior to installing
any option cards by removing both the AC and DC power cords connected to the
equipment.
This unit will contain more than one power source if both the AC and DC power
options are present. In this case, turning off the rear panel power switch will not
remove all power sources.
DANGER! — FUSING:
The equipment has Double Pole/Neutral Line Fusing on AC power.
For continued protection against risk of fire, replace fuses only with same type
and rating of fuse.
DANGER! — GROUNDING: This equipment must be EARTH GROUNDED. Never
defeat the ground connector or operate the equipment in the absence of a suit
ably installed earth ground connection. Contact the appropriate electrical inspec
tion authority or an electrician if you are uncertain that suitable grounding is
available.
CHAPTER •
2 SecureSync User Reference Guide Rev. 23