Option Card Identification; Option Card Identification By Id/Part Number - Spectracom SecureSync 1200 User Reference Manual

Function
Networking Cards
Gigabit Eth
ernet
1Gb PTP:
Master only
Communication and Specialty Cards
Event in, Broad
cast out
Revertive
Selector ("Fail
over")
Alarm Relay
Out
Bidir. Com
munication
1.5.2

Option Card Identification

There are several ways to identify which option card(s) are installed in your SecureSync unit:
a.
b.
1.5.2.1

Option Card Identification by ID/Part Number

If you are looking for information specific to a particular option card, the table below can help
you find this information in this User Reference Guide.
CHAPTER •
1 SecureSync User Reference Guide Rev. 23
Name used in Web UI
Gb Ethernet
Gb PTP
Event Broadcast
n/a
Relay Output
RS-485 Comm
Using the Web UI, navigate to the INTERFACES > OPTION CARDS drop-down menu,
and compare the list displayed in your UI with the table "Option cards overview" on
page 10.
If you have physical access to your SecureSync unit, inspect its rear panel, and compare
the 2-digit ID number printed in the lower left-hand corner on each option card with the
table below.
Note: * Every option card has a 2-digit identification (
found in the corner of its cover plate, and in the table below. The ID number is
Illustration ID* Inputs
06 (3, OR
output)
32 0
23
BNC:
Event
trigger
2E
Frequ.
or 1
PPS:
(2x)
0F
0
0B Yes
1.5 Option Cards
Outputs Conn.'s
(3, OR input) RJ-45
(3x)
1PPS (1x BNC), BNC
SFP (1x) (1x),
SFP (1x)
DB-9: Event DB-9 +
broadcast BNC
(1x
each)
Frequ. or 1PPS BNC
(1x) (3x)
Relay Out (3x) Terminal
block,
10-pin
Yes Terminal
block,
10-pin
ID ) number that can be
13