The Ntp Servers And Ntp Peers Panels - Spectracom SecureSync 1200 User Reference Manual

2.15.8.1 The NTP Servers and NTP Peers Panels

The NTP Servers and NTP Peers panels display which servers in the network are set up at
higher or equal Stratums (Servers or Peers, respectively), and their configurations. These panels
are also used to add, configure, or remove NTP Servers and Peers.
The NTP Servers and NTP Peers panels are part of the NTP Setup screen (see "The NTP Setup
Screen" on page 90), which can be accessed via MANAGEMENT > NETWORK: NTP Setup .
Information provided in the NTP Servers and NTP Peers panels
The following columns are used to break down the status information for recognized NTP Serv
ers and NTP Peers .
CHAPTER •
2 SecureSync User Reference Guide Rev. 23
Note: For information on how to
page 94.
Note: Servers will be displayed in the
They will, however, always be displayed in the
figure them, if necessary.
IP/HOST : Name and real-time status (color-coded)
REF ID : Identifies the type of Input REFerence e.g., GPS indicates the reference can use
GPS for its synchronization. Below is a list of potential REF IDs reported by the
SecureSync Timing System (other NTP Servers and Peers may report different ref
erences):
GPS : GNSS reference
IRIG : IRIG reference
HVQ : HAVE QUICK reference
FREQ : Frequency reference
PPS : External 1PPS reference
PTP : PTP reference
view NTP Clients, see "Viewing NTP Clients" on
Status view only if they can be resolved.
Setup view in order to recon
2.15 Configuring NTP
101